FLYWHEEL STEP: 3.207" - 3.217"
Required: 2
HAS SLOTTED DRIVE PIN HOLES
THIS IS A 50 CM (3 CI) HYDRAULIC PUMP THIS PUMP HAS A 1 1/16" INLET PORT ON THE MOUNTING FLANGE LEFT SIDE , A 7/8" PRESSURE PORT IN THE PUMP BODY ON RIGHT SIDE, A 7/8" COOLER RETURN PORT ON TOP AND A 3/8" DRAIN PORT ON THE BOTTOM. IT DOES NOT HAVE AN INLET PORT ON THE MOUNTING FLANGE RIGHT SIDE. NOTE: THE INDICATED SIDES OF PUMP ARE AS SEEN FROM THE TRACTOR SEAT. IF YOUR APPLICATION DOES NOT HAVE A DRAIN LINE THE INSTALLATION OF J D PART AR39810 DRAIN LINE KIT IS REQUIRED.
1 1/16" MALE O-RING x 7/8" MALE JIC
45 DEGREE HYDRAULIC PUMP FITTING 1 1/16" MALE O-RING x 7/8" MALE JIC
USE WITH R79152, R79154 & R79156 SHAFTS
USE WITH R34348 SHAFT
USE WITH R34348 SHAFT AND USE WITH R45874B & R45874BR BUSHINGS Required: 2
USE WITH R79152, R79154 & R79156 SHAFTS USE WITH R80558B & R80558BR BUSHINGS Required: 2
USE WITH R79152, R79154, R79156 & R34348 SHAFTS Required: 2
THIS SHAFT IS REVERSIBLE 6 SPLINE FOR 540 RPM SHAFT 21 SPLINE FOR 1000 RPM SHAFT
DOES NOT INCLUDE BACKPLATE INCLUDES: MOUNTING GASKET R937520 KIT AVAILABLE
INCLUDES: 2 MOUNTING GASKETS & SEAL
FITS: R48818 & R58705 INCLUDES: 3 GASKETS, SPRING SEAL & BEARING
SEAL INSTALLER FOR THE INSTALLATION OF UNITIZED WATER PUMP SEALS
ONE PIECE TEFLON SEAL AND WEAR SLEEVE ASSEMBLY SUB FOR AT22965, AR92893, RE11036, RE17831, RE24959
3/16" X 31/64"-18 PER SET
UPDATE KIT
HEAVY DUTY BEARING STYLE WITH OE WIRE CONNECTORS 12V SINGLE SPEED 2 WIRE WITH 5/16" SHAFTS
OE WIRE CONNECTORS SEALED MOTOR